悪意ある象牙

TSHIRT SIZE CHART

HOODIE SIZE CHART

To keep your clothing looking fresh and extend the life of your print, follow these simple care instructions:

• Turn It Inside Out: Wash your garment inside out to protect the print from friction and excess wear.
• Wash Cold: Use cold water or low-temperature settings to prevent shrinkage and preserve ink quality.
• Choose Gentle Detergent: Stick to mild, non-aggressive detergents. Avoid bleach or heavy spot treatments directly on the design.
• Dry with Care: Tumble dry on low heat, or go the traditional route and hang dry for best results.

Note: Skipping these steps can cause premature fading, cracking, or extra wear to both the fabric and the print.

Follow this step-by-step application guide to ensure a clean, long-lasting stick for your new decal.

Step 1: Prepare the Surface

• Clean Thoroughly: Make sure your application area is completely free from dirt, dust, and debris.

• Avoid Wax Cleaners: Do not use cleaning products that leave behind wax, oils, or slick additives.

• Prep Correctly: We recommend wiping the area down with 80% isopropyl alcohol or a gentle degreaser that is safe for your surface.

Step 2: Remove the Backing Paper

• Lay It Flat: Place your sticker face down on a flat, clean surface.

• Start the Peel: Fold back the top left corner of the white paper backing.

• Peel Slowly: Carefully pull the backing paper away from the clear transfer tape at a sharp angle.

• Troubleshoot: If any part of the vinyl stays stuck to the backing paper, press the tape back down firmly, wait a few seconds, and try peeling again.

• Position: Once the backing is completely off, lift the sticker by the transfer tape edges and align it over your surface.

Step 3: Apply and Set the Sticker

• Set the Edge: Anchor one edge of the transfer tape onto your desired spot first.

• Smooth It Down: Use a squeegee, credit card, or plastic scraper to apply firm, even pressure working from one side to the other.

• Lock It In: Keep the transfer tape on for a moment. Take the backing paper you removed earlier, lay it over the transfer tape, and apply firm pressure across the whole design once more.

• Peel the Tape: Pick a corner and slowly peel the transfer tape back flat against the surface.

• Final Check: If the vinyl tries to lift with the tape, press the tape back down, rub it firmly, wait a few seconds, and slowly peel it back again.

Tip: Take your time during the peeling steps! Moving slowly ensures every tiny detail transfers smoothly without tearing.